Tweezer support

[kamiewtype]

Any chance for PM120/AM120 hot tweezer support? I saw it mentioned a while ago as a possibility but I have not seen any updates since. This looks much easier to get into than the Unisolder but I worry I'm going to regret the lack of tweezer support.

[AxxAxx]

Hi!
(saw that you asked this question on the Discord)
But short answer here:
It is still on the drawing board. I will hopefully do some tests in the coming months. But at the moment there is just an idea and a rough schematic. So I hope it will come, can not promise it will work and not when in time