This repo documents all the open source components of the ShawnXSprig holiday case.
Did you get a holiday case? Check here for an assembly video
- BackPlate.stl (3d printed): This is the back side of the case that comes in 2 parts: one part mirrored for the other side of the Sprig main board. It should be printed with the nut traps facing down.
- FrontPlate.stl (3d printed): This is the front side of the case that should be printed in multimaterial. It should be printed with the snowman emblem facing up.
- Spacer.stl (3d printed)
- M2x8mm screws (x8)
- M2 nuts (x8)
It's recommended that all parts be printed in PLA, as the frontplate is multi-color. If PETG is substituted, all parts should be PETG, as PLA and PETG do not adhere to each other. All parts should be printed in PLA. So far, we've used:
- Prusament PLA Vanilla White
- Prusament PLA White (substitute for vanilla white when vanilla white is out of stock)
- Prusament PLA Lipstick Red
The FrontPlate requires a color change on the last layer to print the snowman, snowflakes, and text in another color.
For packing a case, you can watch this video.
It is recommended to sink the nuts into the backplate nut traps before shipping shown in this video.