forked from PX4/PX4-Autopilot
-
Notifications
You must be signed in to change notification settings - Fork 0
/
Copy pathposition_setpoint.msg
53 lines (41 loc) · 2.54 KB
/
position_setpoint.msg
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
# this file is only used in the position_setpoint triple as a dependency
uint8 SETPOINT_TYPE_POSITION=0 # position setpoint
uint8 SETPOINT_TYPE_VELOCITY=1 # velocity setpoint
uint8 SETPOINT_TYPE_LOITER=2 # loiter setpoint
uint8 SETPOINT_TYPE_TAKEOFF=3 # takeoff setpoint
uint8 SETPOINT_TYPE_LAND=4 # land setpoint, altitude must be ignored, descend until landing
uint8 SETPOINT_TYPE_IDLE=5 # do nothing, switch off motors or keep at idle speed (MC)
uint8 SETPOINT_TYPE_OFFBOARD=6 # setpoint in NED frame (x, y, z, vx, vy, vz) set by offboard
uint8 SETPOINT_TYPE_FOLLOW_TARGET=7 # setpoint in NED frame (x, y, z, vx, vy, vz) set by follow target
uint8 VELOCITY_FRAME_LOCAL_NED = 1 # MAV_FRAME_LOCAL_NED
uint8 VELOCITY_FRAME_BODY_NED = 8 # MAV_FRAME_BODY_NED
bool valid # true if setpoint is valid
uint8 type # setpoint type to adjust behavior of position controller
float32 x # local position setpoint in m in NED
float32 y # local position setpoint in m in NED
float32 z # local position setpoint in m in NED
bool position_valid # true if local position setpoint valid
float32 vx # local velocity setpoint in m/s in NED
float32 vy # local velocity setpoint in m/s in NED
float32 vz # local velocity setpoint in m/s in NED
bool velocity_valid # true if local velocity setpoint valid
uint8 velocity_frame # to set velocity setpoints in NED or body
bool alt_valid # do not set for 3D position control. Set to true if you want z-position control while doing vx,vy velocity control.
float64 lat # latitude, in deg
float64 lon # longitude, in deg
float32 alt # altitude AMSL, in m
float32 yaw # yaw (only for multirotors), in rad [-PI..PI), NaN = hold current yaw
bool yaw_valid # true if yaw setpoint valid
float32 yawspeed # yawspeed (only for multirotors, in rad/s)
bool yawspeed_valid # true if yawspeed setpoint valid
float32 loiter_radius # loiter radius (only for fixed wing), in m
int8 loiter_direction # loiter direction: 1 = CW, -1 = CCW
float32 pitch_min # minimal pitch angle for fixed wing takeoff waypoints
float32 a_x # acceleration x setpoint
float32 a_y # acceleration y setpoint
float32 a_z # acceleration z setpoint
bool acceleration_valid # true if acceleration setpoint is valid/should be used
bool acceleration_is_force # interprete acceleration as force
float32 acceptance_radius # navigation acceptance_radius if we're doing waypoint navigation
float32 cruising_speed # the generally desired cruising speed (not a hard constraint)
float32 cruising_throttle # the generally desired cruising throttle (not a hard constraint)