-
Notifications
You must be signed in to change notification settings - Fork 0
/
README.bootcount
51 lines (39 loc) · 1.59 KB
/
README.bootcount
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
.. SPDX-License-Identifier: GPL-2.0+
Boot Count Limit
================
This allows to detect multiple failed attempts to boot Linux.
After a power-on reset, "bootcount" variable will be initialized with 1, and
each reboot will increment the value by 1.
If, after a reboot, the new value of "bootcount" exceeds the value of
"bootlimit", then instead of the standard boot action (executing the contents of
"bootcmd") an alternate boot action will be performed, and the contents of
"altbootcmd" will be executed.
If the variable "bootlimit" is not defined in the environment, the Boot Count
Limit feature is disabled. If it is enabled, but "altbootcmd" is not defined,
then U-Boot will drop into interactive mode and remain there.
It is the responsibility of some application code (typically a Linux
application) to reset the variable "bootcount", thus allowing for more boot
cycles.
BOOTCOUNT_EXT
-------------
This adds support for maintaining boot count in a file on an EXT filesystem.
The file to use is define by:
SYS_BOOTCOUNT_EXT_INTERFACE
SYS_BOOTCOUNT_EXT_DEVPART
SYS_BOOTCOUNT_EXT_NAME
The format of the file is:
==== =================
type entry
==== =================
u8 magic
u8 version
u8 bootcount
u8 upgrade_available
==== =================
To prevent unattended usage of "altbootcmd" the "upgrade_available" variable is
used.
If "upgrade_available" is 0, "bootcount" is not saved, if "upgrade_available" is
1 "bootcount" is save.
So the Userspace Application must set the "upgrade_available" and "bootcount"
variables to 0, if a boot was successfully.
This also prevents writes on all reboots.