Supported chips:
BEL PFE1100
Prefixes: 'pfe1100'
Addresses scanned: -
Datasheet: https://www.belfuse.com/resources/datasheets/powersolutions/ds-bps-pfe1100-12-054xa.pdf
BEL PFE3000
Prefixes: 'pfe3000'
Addresses scanned: -
Datasheet: https://www.belfuse.com/resources/datasheets/powersolutions/ds-bps-pfe3000-series.pdf
Author: Tao Ren <[email protected]>
This driver supports hardware monitoring for below power supply devices which support PMBus Protocol:
BEL PFE1100
1100 Watt AC to DC power-factor-corrected (PFC) power supply. PMBus Communication Manual is not publicly available.
BEL PFE3000
3000 Watt AC/DC power-factor-corrected (PFC) and DC-DC power supply. PMBus Communication Manual is not publicly available.
The driver is a client driver to the core PMBus driver. Please see Documentation/hwmon/pmbus.rst for details on PMBus client drivers.
This driver does not auto-detect devices. You will have to instantiate the devices explicitly. Please see Documentation/i2c/instantiating-devices.rst for details.
Example: the following will load the driver for an PFE3000 at address 0x20 on I2C bus #1:
$ modprobe bel-pfe $ echo pfe3000 0x20 > /sys/bus/i2c/devices/i2c-1/new_device
The driver supports standard PMBus driver platform data.
| curr1_label | "iin" |
| curr1_input | Measured input current |
| curr1_max | Input current max value |
| curr1_max_alarm | Input current max alarm |
| curr[2-3]_label | "iout[1-2]" |
| curr[2-3]_input | Measured output current |
| curr[2-3]_max | Output current max value |
| curr[2-3]_max_alarm | Output current max alarm |
| fan[1-2]_input | Fan 1 and 2 speed in RPM |
| fan1_target | Set fan speed reference for both fans |
| in1_label | "vin" |
| in1_input | Measured input voltage |
| in1_crit | Input voltage critical max value |
| in1_crit_alarm | Input voltage critical max alarm |
| in1_lcrit | Input voltage critical min value |
| in1_lcrit_alarm | Input voltage critical min alarm |
| in1_max | Input voltage max value |
| in1_max_alarm | Input voltage max alarm |
| in2_label | "vcap" |
| in2_input | Hold up capacitor voltage |
| in[3-8]_label | "vout[1-3,5-7]" |
| in[3-8]_input | Measured output voltage |
| in[3-4]_alarm | vout[1-2] output voltage alarm |
| power[1-2]_label | "pin[1-2]" |
| power[1-2]_input | Measured input power |
| power[1-2]_alarm | Input power high alarm |
| power[3-4]_label | "pout[1-2]" |
| power[3-4]_input | Measured output power |
| temp[1-3]_input | Measured temperature |
| temp[1-3]_alarm | Temperature alarm |
Note
- curr3, fan2, vout[2-7], vcap, pin2, pout2 and temp3 attributes only exist for PFE3000.