- X.org video driver package: xf86-video-odroid-c1 Note: Add your user to the "video" group to be able to access /dev/mali and /dev/ump.
- Mali EGL and GLES drivers (installed with xf86-video-odroid-c1): odroid-c1-libgl
- wiringPi modified for the ODROID-C1: wiringc1
- Kodi: kodi-c1
To make use of the IR receiver, load module meson-ir
For one PWM (pin 33) and one SPI:
sudo modprobe pwm-peson npwm=1
sudo modprobe pwm-ctrl
For two PWM (pins 33 and 19) and no SPI
sudo modprobe pwm-peson npwm=2
sudo modprobe pwm-ctrl
You can control the PWM via simple sysfs entries. In /sys/devices/platform/pwm-ctrl you'll find the following files:
- duty0: Duty cycle in percent:
echo 50 > duty0 # 50% duty cycle - enable0: Enable/Disable this PWM:
echo 1 > enable0 # enable PWM0 - freq0: PWM Frequency in Hertz:
echo 100000 > freq0 # set frequency to 100kHz- On PWM0 you can test higher frequencies; however, 1Mhz is the maximum supported frequency.
- Note: If you are using the two PWM setup, you will have: enable0, freq0, duty0 AND enable1, freq1, duty1.