Bosch CLC8001i

[roboticsalign]

Dear all,

Thanks for this great project.

I am trying to get a Bosch CLC8001i connected, but the board seems to be different:

CN70 has +5V and GND on pins 0 and 7 and can power the esp. But do you have a recommendation, where RX and TX could be located or how I could search them?

[sven819]

That seems to be a different version of the board, but as far as I know, the CL8000 series also uses the G10 CL-2. Looking at the third-party module from WiHeat on this page the pin assignment appears to match. Please let me know if this is the case so I can include it in the README. The init log might also provide some insight, especially for identifying unknown bytes, since this is a different version. If everything matches, please provide the init log.

Edit:

CN70 seems to be the wrong connector; it should be CN13A

[sven819]

CN70 seems to be the wrong connector; it should be CN13A