The Closed Loop firmware has not yet been completed, but for now it is possible to use the extruder in Open Loop mode with the ARSI firmware for klipper Link
Unfortunately for now the only difficulty in accessing the project is the creation of the rollers that are not available on the market, but you can create them if you can through the drawing that I have provided.
The ORBION project is OpenSource so if you have the pleasure of supporting my next works I will be grateful fot the coffee.
PayPal
Componets:
- Bearing MR63rs (6pcs)
- Springs multi-wave (1pcs)
- M2x4 (13pcs)
- M2x8 (2pcs)
- Encoder ATM 103-v (1pcs)
- SimpleFOC 2.0.4 (1pcs)
- Arduino Uno (1pcs)
- Brushless Gimbal 2804 100KV
- Bearing 6802-2RS (1pcs)
- Bearing MR63rs (6pcs)
- Bearing 684ZZ (1pcs)
- M2x4 (13pcs)
- SimpleFOC 2.0.4 (1pcs)
- Arduino Uno (1pcs)
- Brushless Gimbal 2804 100KV
- Compression Springs (1pcs)
- vvega007 - Creator of the Spiral Extruder on which this project is based
- Rcarlyle (Reddit Nickname) - The first to implement this solution for 3D printing in 2015
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
You are free to:
- Share — copy and redistribute the material in any medium or format
- Adapt - remix, transform, and build upon the material
Under the following terms:
- Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
- NonCommercial — You may not use the material for commercial purposes.