My Documentation for the Rook-2020 3D Printer by Rolohaun
This is a place where you can find all the config files i use on my Rook-2020
All the files posted are my personal setup files for my spesific Rook setup and may not work on your printer.
Please only use my files as a reference.
Use Voron v0 profiles in your slicer.
Please note that my printer uses 300mm Z extrusions and my probe mod for the sentinel, so my macros and configs are set up for this.
This has been built with the kit from Fabreeko.
My Setup:
- Mainboard: SKR Mini E3 V3
- BTT Pi V1.2
- A/B/Z - motors: HoneyBadger Nema-17 40mm Motor
- Extruder motor: Honebadger Nema 14 20mm Pancake Motor
- Extruder: Fabreeko Sherpa kit
- Heatsink: Fabreeko/Trianglelabs CR10/E3
- Hotend: Trianglelabs CHC
- Printbed: LDO 100W Voron V0 Bed with FYSETC PEI/Carbon sheet
- Sentinel toolhead with GX-H8A Inductive probe
- CHT 0.4mm nozzle
Fans:
- Honeybadger 3010 for Sentinel toolhead
- 2x Honebadger 4010 for Sentinel part cooling
- 2x Usongshine 4020 for electronics cooling
- 120mm axiliary fan for part cooling