clocksource: Exynos_mct: Register clock event after request_irq()

After hotplugging CPU1 the first call of interrupt handler for CPU1
oneshot timer was called on CPU0 because it fired before setting IRQ
affinity. Affected are SoCs where Multi Core Timer interrupts are
shared (SPI), e.g. Exynos 4210.

During setup of the MCT timers the clock event device should be
registered after setting the affinity for interrupt. This will prevent
starting the timer too early.

Signed-off-by: Krzysztof Kozlowski <[email protected]>
Signed-off-by: Thomas Gleixner <[email protected]>
Cc: Kyungmin Park <[email protected]>
Cc: Marek Szyprowski <[email protected]>
Cc: Bartlomiej Zolnierkiewicz <[email protected]>
Cc: Tomasz Figa <[email protected]>,
Cc: Daniel Lezcano <[email protected]>,
Cc: Kukjin Kim <[email protected]>
Cc: [email protected],
Cc: [email protected]
Link: http://lkml.kernel.org/r/[email protected]
Signed-off-by: Thomas Gleixner <[email protected]>

drivers/clocksource/exynos_mct.c

@@ -416,8 +416,6 @@ static int exynos4_local_timer_setup(struct clock_event_device *evt)
 	evt->set_mode = exynos4_tick_set_mode;
 	evt->features = CLOCK_EVT_FEAT_PERIODIC | CLOCK_EVT_FEAT_ONESHOT;
 	evt->rating = 450;
-	clockevents_config_and_register(evt, clk_rate / (TICK_BASE_CNT + 1),
-					0xf, 0x7fffffff);
 
 	exynos4_mct_write(TICK_BASE_CNT, mevt->base + MCT_L_TCNTB_OFFSET);
 
@@ -434,6 +432,8 @@ static int exynos4_local_timer_setup(struct clock_event_device *evt)
 	} else {
 		enable_percpu_irq(mct_irqs[MCT_L0_IRQ], 0);
 	}
+	clockevents_config_and_register(evt, clk_rate / (TICK_BASE_CNT + 1),
+					0xf, 0x7fffffff);
 
 	return 0;
 }