hv_netvsc: Fix a network regression after ifdown/ifup

Recently people reported the NIC stops working after
"ifdown eth0; ifup eth0". It turns out in this case the TX queues are not
enabled, after the refactoring of the common detach logic: when the NIC
has sub-channels, usually we enable all the TX queues after all
sub-channels are set up: see rndis_set_subchannel() ->
netif_device_attach(), but in the case of "ifdown eth0; ifup eth0" where
the number of channels doesn't change, we also must make sure the TX queues
are enabled. The patch fixes the regression.

Fixes: 7b2ee50 ("hv_netvsc: common detach logic")
Signed-off-by: Dexuan Cui <[email protected]>
Cc: Stephen Hemminger <[email protected]>
Cc: K. Y. Srinivasan <[email protected]>
Cc: Haiyang Zhang <[email protected]>
Signed-off-by: David S. Miller <[email protected]>

drivers/net/hyperv/netvsc_drv.c

@@ -127,8 +127,10 @@ static int netvsc_open(struct net_device *net)
 	}
 
 	rdev = nvdev->extension;
-	if (!rdev->link_state)
+	if (!rdev->link_state) {
 		netif_carrier_on(net);
+		netif_tx_wake_all_queues(net);
+	}
 
 	if (vf_netdev) {
 		/* Setting synthetic device up transparently sets