Merge tag '64bit-for-linus' of git://git.kernel.org/pub/scm/linux/ker…

…nel/git/arm/arm-soc

Pull ARM SoC 64-bit changes and additions from Olof Johansson:
 "The 64-bit set of updates this release cycle adds support for three
  new platforms:

   - Samsunc Exynos 7
   - Freescale LS2085a
   - Mediatek MT8173

  For all these, the changes mostly consititude additions of DT
  contents, but also some Kconfig entries to allow dependency/selection
  of drivers per-platform, etc"

* tag '64bit-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc:
  arm64: Kconfig: clean up two no-op Kconfig options from CONFIG_ARCH_TEGRA*
  arm64: Fix sort of platform Kconfig entries
  arm64: Add support for FSL's LS2085A SoC in Kconfig and defconfig
  arm64: Add DTS support for FSL's LS2085A SoC
  arm64: mediatek: Add MT8173 SoC Kconfig and defconfig
  arm64: dts: Add mediatek MT8173 SoC and evaluation board dts and Makefile
  Document: DT: Add bindings for mediatek MT8173 SoC Platform
  arm64: Add Tegra132 support
  arm64: Enable ARMv8 based exynos7 SoC support
  arm64: dts: Add nodes for mmc, i2c, rtc, watchdog, adc on exynos7
  arm64: dts: Add PMU DT node for exynos7 SoC
  arm64: dts: Add initial pinctrl support to exynos7
  arm64: dts: Add initial device tree support for exynos7

Documentation/devicetree/bindings/arm/mediatek.txt

@@ -9,6 +9,7 @@ compatible: Must contain one of
    "mediatek,mt6592"
    "mediatek,mt8127"
    "mediatek,mt8135"
+   "mediatek,mt8173"
 
 
 Supported boards:
@@ -25,3 +26,6 @@ Supported boards:
 - MTK mt8135 tablet EVB:
     Required root node properties:
       - compatible = "mediatek,mt8135-evbp1", "mediatek,mt8135";
+- MTK mt8173 tablet EVB:
+    Required root node properties:
+      - compatible = "mediatek,mt8173-evb", "mediatek,mt8173";

Documentation/devicetree/bindings/arm/mediatek/mediatek,sysirq.txt

@@ -5,6 +5,7 @@ interrupt.
 
 Required properties:
 - compatible: should be one of:
+	"mediatek,mt8173-sysirq"
 	"mediatek,mt8135-sysirq"
 	"mediatek,mt8127-sysirq"
 	"mediatek,mt6592-sysirq"

Documentation/devicetree/bindings/arm/samsung/pmu.txt

@@ -10,6 +10,7 @@ Properties:
 		   - "samsung,exynos5260-pmu" - for Exynos5260 SoC.
 		   - "samsung,exynos5410-pmu" - for Exynos5410 SoC,
 		   - "samsung,exynos5420-pmu" - for Exynos5420 SoC.
+		   - "samsung,exynos7-pmu" - for Exynos7 SoC.
 		second value must be always "syscon".
 
  - reg : offset and length of the register set.

Documentation/devicetree/bindings/serial/mtk-uart.txt

@@ -4,9 +4,11 @@ Required properties:
 - compatible should contain:
   * "mediatek,mt8135-uart" for MT8135 compatible UARTS
   * "mediatek,mt8127-uart" for MT8127 compatible UARTS
+  * "mediatek,mt8173-uart" for MT8173 compatible UARTS
   * "mediatek,mt6589-uart" for MT6589 compatible UARTS
   * "mediatek,mt6582-uart" for MT6582 compatible UARTS
-  * "mediatek,mt6577-uart" for all compatible UARTS (MT6589, MT6582, MT6577)
+  * "mediatek,mt6577-uart" for all compatible UARTS (MT8173, MT6589, MT6582, 
+	MT6577)
 
 - reg: The base address of the UART register bank.
 

arch/arm64/Kconfig

@@ -149,11 +149,65 @@ source "kernel/Kconfig.freezer"
 
 menu "Platform selection"
 
+config ARCH_EXYNOS
+	bool
+	help
+	  This enables support for Samsung Exynos SoC family
+
+config ARCH_EXYNOS7
+	bool "ARMv8 based Samsung Exynos7"
+	select ARCH_EXYNOS
+	select COMMON_CLK_SAMSUNG
+	select HAVE_S3C2410_WATCHDOG if WATCHDOG
+	select HAVE_S3C_RTC if RTC_CLASS
+	select PINCTRL
+	select PINCTRL_EXYNOS
+
+	help
+	  This enables support for Samsung Exynos7 SoC family
+
+config ARCH_FSL_LS2085A
+	bool "Freescale LS2085A SOC"
+	help
+	  This enables support for Freescale LS2085A SOC.
+
+config ARCH_MEDIATEK
+	bool "Mediatek MT65xx & MT81xx ARMv8 SoC"
+	select ARM_GIC
+	help
+	  Support for Mediatek MT65xx & MT81xx ARMv8 SoCs
+
 config ARCH_SEATTLE
 	bool "AMD Seattle SoC Family"
 	help
 	  This enables support for AMD Seattle SOC Family
 
+config ARCH_TEGRA
+	bool "NVIDIA Tegra SoC Family"
+	select ARCH_HAS_RESET_CONTROLLER
+	select ARCH_REQUIRE_GPIOLIB
+	select CLKDEV_LOOKUP
+	select CLKSRC_MMIO
+	select CLKSRC_OF
+	select GENERIC_CLOCKEVENTS
+	select HAVE_CLK
+	select PINCTRL
+	select RESET_CONTROLLER
+	help
+	  This enables support for the NVIDIA Tegra SoC family.
+
+config ARCH_TEGRA_132_SOC
+	bool "NVIDIA Tegra132 SoC"
+	depends on ARCH_TEGRA
+	select PINCTRL_TEGRA124
+	select USB_ULPI if USB_PHY
+	select USB_ULPI_VIEWPORT if USB_PHY
+	help
+	  Enable support for NVIDIA Tegra132 SoC, based on the Denver
+	  ARMv8 CPU.  The Tegra132 SoC is similar to the Tegra124 SoC,
+	  but contains an NVIDIA Denver CPU complex in place of
+	  Tegra124's "4+1" Cortex-A15 CPU complex.
+
 config ARCH_THUNDER
 	bool "Cavium Inc. Thunder SoC Family"
 	help

arch/arm64/boot/dts/Makefile

@@ -2,5 +2,8 @@ dts-dirs += amd
 dts-dirs += apm
 dts-dirs += arm
 dts-dirs += cavium
+dts-dirs += exynos
+dts-dirs += freescale
+dts-dirs += mediatek
 
 subdir-y	:= $(dts-dirs)

arch/arm64/boot/dts/exynos/Makefile

@@ -0,0 +1,5 @@
+dtb-$(CONFIG_ARCH_EXYNOS7) += exynos7-espresso.dtb
+
+always		:= $(dtb-y)
+subdir-y	:= $(dts-dirs)
+clean-files	:= *.dtb

arch/arm64/boot/dts/exynos/exynos7-espresso.dts

@@ -0,0 +1,84 @@
+/*
+ * SAMSUNG Exynos7 Espresso board device tree source
+ *
+ * Copyright (c) 2014 Samsung Electronics Co., Ltd.
+ *		http://www.samsung.com
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+*/
+
+/dts-v1/;
+#include "exynos7.dtsi"
+
+/ {
+	model = "Samsung Exynos7 Espresso board based on EXYNOS7";
+	compatible = "samsung,exynos7-espresso", "samsung,exynos7";
+
+	aliases {
+		serial0 = &serial_2;
+		mshc0 = &mmc_0;
+		mshc2 = &mmc_2;
+	};
+
+	chosen {
+		linux,stdout-path = &serial_2;
+	};
+
+	memory@40000000 {
+		device_type = "memory";
+		reg = <0x0 0x40000000 0x0 0xC0000000>;
+	};
+};
+
+&fin_pll {
+	clock-frequency = <24000000>;
+};
+
+&serial_2 {
+	status = "okay";
+};
+
+&rtc {
+	status = "okay";
+};
+
+&watchdog {
+	status = "okay";
+};
+
+&adc {
+	status = "okay";
+};
+
+&mmc_0 {
+	status = "okay";
+	num-slots = <1>;
+	broken-cd;
+	cap-mmc-highspeed;
+	non-removable;
+	card-detect-delay = <200>;
+	clock-frequency = <800000000>;
+	samsung,dw-mshc-ciu-div = <3>;
+	samsung,dw-mshc-sdr-timing = <0 4>;
+	samsung,dw-mshc-ddr-timing = <0 2>;
+	pinctrl-names = "default";
+	pinctrl-0 = <&sd0_clk &sd0_cmd &sd0_qrdy &sd0_bus1 &sd0_bus4 &sd0_bus8>;
+	bus-width = <8>;
+};
+
+&mmc_2 {
+	status = "okay";
+	num-slots = <1>;
+	cap-sd-highspeed;
+	card-detect-delay = <200>;
+	clock-frequency = <400000000>;
+	samsung,dw-mshc-ciu-div = <3>;
+	samsung,dw-mshc-sdr-timing = <2 3>;
+	samsung,dw-mshc-ddr-timing = <1 2>;
+	pinctrl-names = "default";
+	pinctrl-0 = <&sd2_clk &sd2_cmd &sd2_cd &sd2_bus1 &sd2_bus4>;
+	bus-width = <4>;
+	disable-wp;
+};