rt2800pci: Fix 'Error - MCU request failed' during initialization

Bring MCU operations during device initialization to sync with legacy driver. This should fix following error: phy0 -> rt2800pci_mcu_status: Error - MCU request failed, no response from hardware Signed-off-by: Jakub Kicinski <[email protected]> Acked-by: Gertjan van Wingerde <[email protected]> Acked-by: Ivo van Doorn <[email protected]> Signed-off-by: John W. Linville <[email protected]>
erimatnor · Feb 27, 2012 · e8b461c · e8b461c
1 parent 09a3311
commit e8b461c
Showing 1 changed file with 17 additions and 8 deletions.
diff --git a/drivers/net/wireless/rt2x00/rt2800pci.c b/drivers/net/wireless/rt2x00/rt2800pci.c
@@ -502,11 +502,27 @@ static int rt2800pci_init_registers(struct rt2x00_dev *rt2x00dev)
 
 static int rt2800pci_enable_radio(struct rt2x00_dev *rt2x00dev)
 {
+	int retval;
+
 	if (unlikely(rt2800_wait_wpdma_ready(rt2x00dev) ||
 		     rt2800pci_init_queues(rt2x00dev)))
 		return -EIO;
 
-	return rt2800_enable_radio(rt2x00dev);
+	retval = rt2800_enable_radio(rt2x00dev);
+	if (retval)
+		return retval;
+
+	/* After resume MCU_BOOT_SIGNAL will trash these. */
+	rt2x00pci_register_write(rt2x00dev, H2M_MAILBOX_STATUS, ~0);
+	rt2x00pci_register_write(rt2x00dev, H2M_MAILBOX_CID, ~0);
+
+	rt2800_mcu_request(rt2x00dev, MCU_SLEEP, TOKEN_RADIO_OFF, 0xff, 0x02);
+	rt2800pci_mcu_status(rt2x00dev, TOKEN_RADIO_OFF);
+
+	rt2800_mcu_request(rt2x00dev, MCU_WAKEUP, TOKEN_WAKEUP, 0, 0);
+	rt2800pci_mcu_status(rt2x00dev, TOKEN_WAKEUP);
+
+	return retval;
 }
 
 static void rt2800pci_disable_radio(struct rt2x00_dev *rt2x00dev)
@@ -544,13 +560,6 @@ static int rt2800pci_set_device_state(struct rt2x00_dev *rt2x00dev,
 
 	switch (state) {
 	case STATE_RADIO_ON:
-		/*
-		 * Before the radio can be enabled, the device first has
-		 * to be woken up. After that it needs a bit of time
-		 * to be fully awake and then the radio can be enabled.
-		 */
-		rt2800pci_set_state(rt2x00dev, STATE_AWAKE);
-		msleep(1);
 		retval = rt2800pci_enable_radio(rt2x00dev);
 		break;
 	case STATE_RADIO_OFF: