i2c-designware: split of i2c-designware.c into core and bus specific …

…parts

This patch splits i2c-designware.c into three pieces:
     i2c-designware-core.c, contains the code that interacts directly
     with the core.

     i2c-designware-platdrv.c, contains the code specific to the
     platform driver using the core.

     i2c-designware-core.h contains the definitions and declareations
     shared by i2c-designware-core.c and i2c-designware-platdrv.c.

This patch is the first in a set to allow multiple instances of the
designware I2C core in the system.

Signed-off-by: Dirk Brandewie <[email protected]>
Signed-off-by: Ben Dooks <[email protected]>

drivers/i2c/busses/Kconfig

@@ -350,15 +350,15 @@ config I2C_DAVINCI
 	  devices such as DaVinci NIC.
 	  For details please see http://www.ti.com/davinci
 
-config I2C_DESIGNWARE
-	tristate "Synopsys DesignWare"
+config I2C_DESIGNWARE_PLATFORM
+	tristate "Synopsys DesignWare Platfrom"
 	depends on HAVE_CLK
 	help
 	  If you say yes to this option, support will be included for the
 	  Synopsys DesignWare I2C adapter. Only master mode is supported.
 
 	  This driver can also be built as a module.  If so, the module
-	  will be called i2c-designware.
+	  will be called i2c-designware-platform.
 
 config I2C_GPIO
 	tristate "GPIO-based bitbanging I2C"

drivers/i2c/busses/Makefile

@@ -33,7 +33,8 @@ obj-$(CONFIG_I2C_AU1550)	+= i2c-au1550.o
 obj-$(CONFIG_I2C_BLACKFIN_TWI)	+= i2c-bfin-twi.o
 obj-$(CONFIG_I2C_CPM)		+= i2c-cpm.o
 obj-$(CONFIG_I2C_DAVINCI)	+= i2c-davinci.o
-obj-$(CONFIG_I2C_DESIGNWARE)	+= i2c-designware.o
+obj-$(CONFIG_I2C_DESIGNWARE_PLATFORM)	+= i2c-designware-platform.o
+i2c-designware-platform-objs := i2c-designware-platdrv.o i2c-designware-core.o
 obj-$(CONFIG_I2C_GPIO)		+= i2c-gpio.o
 obj-$(CONFIG_I2C_HIGHLANDER)	+= i2c-highlander.o
 obj-$(CONFIG_I2C_IBM_IIC)	+= i2c-ibm_iic.o