OctoPrint PSU Control - Tenda Beli SP3

Adds Tenda Beli SP3 support to OctoPrint-PSUControl as a sub-plugin.

This plugin is based on OctoPrint PSU Control - Tasmota plugin code by Shawn Bruce.

Setup

• Install via the bundled Plugin Manager or manually using this URL: https://github.com/jgroman/OctoPrint-PSUControl-TendaBeli/archive/master.zip

Configuration

• Configure this plugin: set smart plug IP address
• Select this plugin as a Switching and/or Sensing method in PSU Control

Notes

• Plugin was tested with plugs:

  • HW version EU V1.0, SW version V1.1.0.13(115)_SP3_EU
  • HW version AU V1.0, SW version V1.1.0.13(115)_SP3_AU

• Tenda Beli SP3 smart plug can be configured using official Tenda Beli app.

• If you prefer not connecting your SP3 smart plug to any cloud, it is also possible to provision your device manually:

  1. Unpack new device or reset existing device by holding the Power On/Reset button for more than 6 seconds.
  2. Connect to open WLAN provided by this plug
  3. Find out smart plug IP address (= WLAN gateway)
  4. Run command curl -X POST http://PLUG-IP:5000/guideDone -d '{"account":"1","key":"YOUR-WLAN-KEY","server":"beli.intranet","ssid":"YOUR-WLAN-SSID"}'
  5. Smart plug will reset and connect to provided WLAN.