remove the broken ETRAX_IDE driver

ETRAX_IDE was marked as broken last year with the comment
"it doesn't even compile currently".

Remove it since it won't get fixed in the near future.

On Mon, Apr 14, 2008 at 02:50:19PM +0200, Mikael Starvik wrote:
> You can remove it for now and we will resubmit a new if/when we get around
> to fix it.

[bart: ported it over IDE tree]

Signed-off-by: Adrian Bunk <[email protected]>
Cc: Mikael Starvik <[email protected]>
Cc: Jesper Nilsson <[email protected]>
Signed-off-by: Bartlomiej Zolnierkiewicz <[email protected]>

drivers/ide/Kconfig

@@ -862,40 +862,6 @@ config BLK_DEV_IDE_BAST
 	  Say Y here if you want to support the onboard IDE channels on the
 	  Simtec BAST or the Thorcom VR1000
 
-config ETRAX_IDE
-	tristate "ETRAX IDE support"
-	depends on CRIS && BROKEN
-	select BLK_DEV_IDEDMA
-	help
-	  Enables the ETRAX IDE driver.
-
-	  You can't use parallel ports or SCSI ports at the same time.
-
-config ETRAX_IDE_DELAY
-	int "Delay for drives to regain consciousness"
-	depends on ETRAX_IDE && ETRAX_ARCH_V10
-	default 15
-	help
-	  Number of seconds to wait for IDE drives to spin up after an IDE
-	  reset.
-
-choice
-	prompt "IDE reset pin"
-	depends on ETRAX_IDE && ETRAX_ARCH_V10
-	default ETRAX_IDE_PB7_RESET
-
-config ETRAX_IDE_PB7_RESET
-	bool "Port_PB_Bit_7"
-	help
-	  IDE reset on pin 7 on port B
-
-config ETRAX_IDE_G27_RESET
-	bool "Port_G_Bit_27"
-	help
-	  IDE reset on pin 27 on port G
-
-endchoice
-
 config IDE_H8300
 	tristate "H8300 IDE support"
 	depends on H8300

drivers/ide/Makefile

@@ -35,7 +35,7 @@ ifeq ($(CONFIG_BLK_DEV_CMD640), y)
 	obj-y += cmd640-core.o
 endif
 
-obj-$(CONFIG_BLK_DEV_IDE)		+= cris/ ppc/
+obj-$(CONFIG_BLK_DEV_IDE)		+= ppc/
 obj-$(CONFIG_IDE_H8300)			+= h8300/
 obj-$(CONFIG_IDE_GENERIC)		+= ide-generic.o
 obj-$(CONFIG_BLK_DEV_IDEPNP)		+= ide-pnp.o