Merge tag 'omap-for-v3.13/dt-late' of git://git.kernel.org/pub/scm/li…

…nux/kernel/git/tmlind/linux-omap into next/dt

Some more dts changes from Benoit Cousson <[email protected]> via
Tony Lindgren:

- Add a lot of N900 nodes
- Add OPP table to OMAP5/DRA7
- Add support for Newflow NanoBone board
- Add i2c aliases
- Add McASP and audio support
- Add reset/idle on init bindings for OMAP
- Add more nodes for AM4272

* tag 'omap-for-v3.13/dt-late' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap: (42 commits)
  ARM: dts: omap5-uevm: Remove pinmux for dmic pins
  ARM: dts: omap5-uevm: Correct twl6040 reset GPIO pinmux
  ARM: dts: TWL4030: Add power button support
  ARM: dts: omap3-n900: Add LP5523 support
  ARM: dts: omap3-n900: Add TLV320AIC3X support
  ARM: dts: omap3-n900:: Mux RX51_LCD_RESET_GPIO in DTS
  ARM: dts: omap3-n900: Add NAND support
  ARM: dts: omap3-n900: Specify regulator info
  ARM: dts: TWL4030: Add missing regulators
  ARM: dts: omap3-n900: Add LP5523 support
  ARM: dts: omap3-n900: Add vibrator device
  ARM: dts: omap3-n900: GPIO key definitions
  ARM: dts: omap3-n900: Add support for SD cards
  ARM: dts: omap3-n900: Add UART support
  ARM: dts: omap3-n900: Fix i2c bus speed
  ARM: dts: omap3-n900: Add pinctrl for i2c devices
  ARM: dts: DRA7: Add CPU OPP table
  ARM: dts: OMAP5: Add CPU OPP table
  ARM: dts: dra7-evm: add smps123 supply for CPU
  ARM: dts: omap5-uevm: add smps123 supply for CPU
  ...

Signed-off-by: Olof Johansson <[email protected]>

Documentation/devicetree/bindings/arm/omap/omap.txt

@@ -21,7 +21,8 @@ Required properties:
 Optional properties:
 - ti,no_idle_on_suspend: When present, it prevents the PM to idle the module
   during suspend.
-
+- ti,no-reset-on-init: When present, the module should not be reset at init
+- ti,no-idle-on-init: When present, the module should not be idled at init
 
 Example:
 

MAINTAINERS

@@ -6088,6 +6088,12 @@ L:	[email protected]
 S:	Maintained
 F:	drivers/gpio/gpio-omap.c
 
+OMAP/NEWFLOW NANOBONE MACHINE SUPPORT
+M:	Mark Jackson <[email protected]>
+L:	[email protected]
+S:	Maintained
+F:	arch/arm/boot/dts/am335x-nano.dts
+
 OMFS FILESYSTEM
 M:	Bob Copeland <[email protected]>
 L:	[email protected]

arch/arm/boot/dts/Makefile

@@ -197,6 +197,7 @@ dtb-$(CONFIG_ARCH_OMAP2PLUS) += omap2420-h4.dtb \
 	am335x-evmsk.dtb \
 	am335x-bone.dtb \
 	am335x-boneblack.dtb \
+	am335x-nano.dtb \
 	am335x-base0033.dtb \
 	am3517-evm.dtb \
 	am3517_mt_ventoux.dtb \

arch/arm/boot/dts/am335x-evm.dts

@@ -119,6 +119,19 @@
 			};
 		};
 	};
+
+	sound {
+		compatible = "ti,da830-evm-audio";
+		ti,model = "AM335x-EVM";
+		ti,audio-codec = <&tlv320aic3106>;
+		ti,mcasp-controller = <&mcasp1>;
+		ti,codec-clock-rate = <12000000>;
+		ti,audio-routing =
+			"Headphone Jack",       "HPLOUT",
+			"Headphone Jack",       "HPROUT",
+			"LINE1L",               "Line In",
+			"LINE1R",               "Line In";
+	};
 };
 
 &am33xx_pinmux {
@@ -279,6 +292,15 @@
 			0xec 0x00	/* lcd_ac_bias_en.lcd_ac_bias_en, OUTPUT | MODE0 */
 		>;
 	};
+
+	am335x_evm_audio_pins: am335x_evm_audio_pins {
+		pinctrl-single,pins = <
+			0x10c (PIN_INPUT_PULLDOWN | MUX_MODE4) /* mii1_rx_dv.mcasp1_aclkx */
+			0x110 (PIN_INPUT_PULLDOWN | MUX_MODE4) /* mii1_txd3.mcasp1_fsx */
+			0x108 (PIN_OUTPUT_PULLDOWN | MUX_MODE4) /* mii1_col.mcasp1_axr2 */
+			0x144 (PIN_INPUT_PULLDOWN | MUX_MODE4) /* rmii1_ref_clk.mcasp1_axr3 */
+		>;
+	};
 };
 
 &uart0 {
@@ -373,6 +395,18 @@
 		compatible = "ti,tmp275";
 		reg = <0x48>;
 	};
+
+	tlv320aic3106: tlv320aic3106@1b {
+		compatible = "ti,tlv320aic3106";
+		reg = <0x1b>;
+		status = "okay";
+
+		/* Regulators */
+		AVDD-supply = <&vaux2_reg>;
+		IOVDD-supply = <&vaux2_reg>;
+		DRVDD-supply = <&vaux2_reg>;
+		DVDD-supply = <&vbat>;
+	};
 };
 
 &lcdc {
@@ -476,6 +510,22 @@
 
 #include "tps65910.dtsi"
 
+&mcasp1 {
+		pinctrl-names = "default";
+		pinctrl-0 = <&am335x_evm_audio_pins>;
+
+		status = "okay";
+
+		op-mode = <0>;          /* MCASP_IIS_MODE */
+		tdm-slots = <2>;
+		/* 4 serializers */
+		serial-dir = <  /* 0: INACTIVE, 1: TX, 2: RX */
+			0 0 1 2
+		>;
+		tx-num-evt = <1>;
+		rx-num-evt = <1>;
+};
+
 &tps {
 	vcc1-supply = <&vbat>;
 	vcc2-supply = <&vbat>;

arch/arm/boot/dts/am335x-evmsk.dts

@@ -115,6 +115,17 @@
 		brightness-levels = <0 58 61 66 75 90 125 170 255>;
 		default-brightness-level = <8>;
 	};
+
+	sound {
+		compatible = "ti,da830-evm-audio";
+		ti,model = "AM335x-EVMSK";
+		ti,audio-codec = <&tlv320aic3106>;
+		ti,mcasp-controller = <&mcasp1>;
+		ti,codec-clock-rate = <24576000>;
+		ti,audio-routing =
+			"Headphone Jack",       "HPLOUT",
+			"Headphone Jack",       "HPROUT";
+	};
 };
 
 &am33xx_pinmux {
@@ -244,6 +255,15 @@
 			0x14c (PIN_INPUT_PULLDOWN | MUX_MODE7)
 		>;
 	};
+
+	mcasp1_pins: mcasp1_pins {
+		pinctrl-single,pins = <
+			0x10c (PIN_INPUT_PULLDOWN | MUX_MODE4) /* mii1_crs.mcasp1_aclkx */
+			0x110 (PIN_INPUT_PULLDOWN | MUX_MODE4) /* mii1_rxerr.mcasp1_fsx */
+			0x108 (PIN_OUTPUT_PULLDOWN | MUX_MODE4) /* mii1_col.mcasp1_axr2 */
+			0x144 (PIN_INPUT_PULLDOWN | MUX_MODE4) /* rmii1_ref_clk.mcasp1_axr3 */
+		>;
+	};
 };
 
 &uart0 {
@@ -291,6 +311,18 @@
 		st,max-limit-y = <550>;
 		st,max-limit-z = <750>;
 	};
+
+	tlv320aic3106: tlv320aic3106@1b {
+		compatible = "ti,tlv320aic3106";
+		reg = <0x1b>;
+		status = "okay";
+
+		/* Regulators */
+		AVDD-supply = <&vaux2_reg>;
+		IOVDD-supply = <&vaux2_reg>;
+		DRVDD-supply = <&vaux2_reg>;
+		DVDD-supply = <&vbat>;
+	};
 };
 
 &usb {
@@ -433,3 +465,23 @@
 &aes {
 	status = "okay";
 };
+
+&gpio0 {
+	ti,no-reset-on-init;
+};
+
+&mcasp1 {
+		pinctrl-names = "default";
+		pinctrl-0 = <&mcasp1_pins>;
+
+		status = "okay";
+
+		op-mode = <0>;          /* MCASP_IIS_MODE */
+		tdm-slots = <2>;
+		/* 4 serializers */
+		serial-dir = <  /* 0: INACTIVE, 1: TX, 2: RX */
+			0 0 1 2
+		>;
+		tx-num-evt = <1>;
+		rx-num-evt = <1>;
+};

arch/arm/boot/dts/am335x-igep0033.dtsi

@@ -44,6 +44,13 @@
 		regulator-max-microvolt = <5000000>;
 		regulator-boot-on;
 	};
+
+	vmmc: fixedregulator@0 {
+		compatible = "regulator-fixed";
+		regulator-name = "vmmc";
+		regulator-min-microvolt = <3300000>;
+		regulator-max-microvolt = <3300000>;
+	};
 };
 
 &am33xx_pinmux {
@@ -180,6 +187,12 @@
 	};
 };
 
+&mmc1 {
+	status = "okay";
+	vmmc-supply = <&vmmc>;
+	bus-width = <4>;
+};
+
 &uart0 {
 	status = "okay";
 	pinctrl-names = "default";