Voron Zero RGB Side Panels

Side panels for the Voron Zero printer with 16 WS2812 RGB LED's per side.

The build below has some 3mm TAP Plastic black LED acrylic installed INSIDE the frame extrusions to diffuse the LEDs. They are cut per the DXF and the PDF in the CAD folder.

NOTE: The notched corners are intended to go in the front corners to allow the panel to clear the bottom blind joint. My prefernce is to have the matte finish towards the inside of the printer as the glossy side is easy to scratch and scratches are very visible.

I've published the files also over on PCBWays project site!

https://www.pcbway.com/project/shareproject/Voron_Zero_Side_Panel___Left.html

https://www.pcbway.com/project/shareproject/Voron_Zero_Side_Panel___Right.html

Build steps

1. Order set of PCB's.
2. Order 32 5050 RGB/RGBW LED's.
3. Print replacement panel clips.
4. Assemble PCB's with your choice of 0.1" 6 pin connector (JST-XH, Dupont, bare wire).
5. Plug in and test.
6. DONE!